Radio-shack 900MHz Manuel d'utilisateur télécharger pdf (Page 20)

20

Memory Operation

normally would by pressing the ring-

ing line’s button. The intercom call

automatically disconnects.

USING A HEADSET

You can make or answer calls with

handsfree convenience using an option-

al headset (available at your local Ra-

dioShack store) that has a

3

/

32

-inch (2.5

mm) plug.

To connect the headset, pull open the

rubber cover on the side of the handset,

then insert the

3

/

32

-inch (2.5 mm) plug

into the jack.

Notes:

• Connecting a headset disconnects

the handset’s earpiece and micro-

phone, but it does not affect the

phone’s speakerphone.

•

VOLUME

on the handset also con-

trols the connected headset’s vol-

ume.

• If you place the handset on the base

facedown to recharge it while the

headset is connected, be sure the

handset seats properly.

With a headset connected, you can

make or answer calls as usual, using the

keys on the handset.

You can use a handset holder (available

from your local RadioShack store) to

hang the handset on your belt for great-

er convenience.

When you finish using the headset, dis-

connect it from the handset and close

the rubber cover to protect the jack.

ˆ

Memory Operation

You can store up to 10 numbers in the

memory, then dial a stored number by

pressing a single digit memory location

number.

STORING A NUMBER IN

MEMORY

Notes:

• An error tone sounds and the phone

exits the storing process if you wait

more than 20 seconds between key

presses.

• Each number you store can be up to

16 digits long.

1. Lift the handset.

2. Press

MEM

. Both the line indicators

on the handset flash.

3. Enter the number and any tone or

pause entries (see “Using Tone Ser-

vices On a Pulse Line” on Page 19

or “Entering a Pause” on Page 21).

Note:

Each tone or pause entry

uses one digit of memory.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Commentaires sur ces manuels

Pas de commentaire