Radio Shack Mobile Robot Manuel d'utilisateur télécharger pdf (Page 12)

Assembly Overview

ARobot’s assembly normally takes about 2 hours or less excluding time for painting. Children as young

as 10 can build ARobot with the help of an adult. The controller board and cables are pre-built, so sol-

dering is not required.

During assembly you will do these things:

  Sand and paint the metal robot body pieces (this is optional).

  Mounting whiskers, drive motor, steering motor, wheels, etc.

  Route cables.

  Install the Basic Stamp II onto the controller board.

You’ll learn:

  Identification and names of all parts.

  Screw, nut, and washer sizes.

  Basic electronic terminology.

  Basic mechanical assembly techniques.

  Basic wiring skills.

Tools you’ll need:

  Medium Phillips screwdriver

  Needle nose pliers

  Sand paper (200-600 grit), or file

  Wire cutters

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 53 54

Pas de commentaire

Radio Shack Mobile Robot Manuel d'utilisateur Page 12