Radio Shack 12-1686 Spécifications télécharger pdf (Page 14)

DATA

PLUS

REGULATOR ATTACHMENT

If you have purchased the DataPlus in a console version, you will need to have it

attached to your regulator first stage by an Authorized Oceanic Dealer.

ACTIVATING THE DISPLAY

You activate the DataPlus by pressing and releasing the control button located

below the display (Fig. 1a). Depressing and holding the control button for 8

seconds will allow you to enter the External Access Mode used when you down-

load (copy) dive data from the DataPlus to the OceanLink™ PC software logging

program that is available separately. Depressing the button during the Dive

Mode will activate the unit's temperature and Oceanglo

backlight features.

After a diagnostic check that lasts several seconds, the DataPlus advances

through a sequence of displays, called the Surface Sequence, that will repeat

continually until a dive is made, or until the unit shuts off automatically. First

to appear will be Surface Mode, followed by FO2, then PO2 (if FO2 is 'set'), and

the Pre Dive Planning Sequence. After a dive is made, Time to Fly will appear

prior to FO2. These displays will all be explained as you read through this guide.

The 'pre dive' Surface Mode identified by the Surface Mode icon (Fig. 1b) and

the number "0" indicating that no dive has been made since activation. The

Fig. 1 - Surface Mode

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 105 106

Pas de commentaire

Radio Shack 12-1686 Spécifications Page 14