Radio Shack Easy Remote Manuel du propriétaire télécharger pdf (Page 23)

Operation

3. To exit Home Theater mode, press the device key

of the desired mode.

USING MANUAL CODE SEARCH

If your home entertainment device does not respond

to remote control commands after trying all of the

codes listed for your brand, or if your brand is not list-

ed, try searching for your code.

Follow these steps to search for codes manually.

1. Turn on the desired device.

2. On the 6-In-One Remote, press the appropriate

device key once.

3. Hold down

until the red light blinks twice.

4. Press

9 9 1

. The red light blinks twice.

5. Aim the 6-In-One Remote at the desired device

and slowly alternate between pressing

POWER

and the appropriate device key. Stop when the

device turns off — a working code has been

found.

Note:

In the search mode, the remote sends IR

codes from its extensive library to the selected

device, starting with the most popular codes.

Because of the library’s size, this procedure may

take some time. When the red light blinks three

times, the search of every code is complete.

6. Press

once to lock in the code.

Note:

If the device turns off during the search, but

does not operate after you lock in the code, begin the

search again, pausing longer between key presses.

Checking Your Code

If you set up the remote control using the manual code

search procedure, you can use the following instruc-

tions to find out what code is operating your equip-

ment:

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 47 48

Pas de commentaire

Radio Shack Easy Remote Manuel du propriétaire Page 23