Radio-shack MPA-125 Manuel d'utilisateur télécharger pdf (Page 17)

Care and Maintenance

REPLACING THE FUSE

If the amplifier does not operate, you might

need to replace the fuse on the back of the

amplifier with the supplied (or another) 3-

amp, 250-volt fuse.

Important:

Let the amplifier cool down and

see if it starts again before you assume a

fuse needs to be replaced.

Caution:

Do not use a fuse with ratings other

than those specified. Doing so might damage

your amplifier.

1. Unplug the amplifier.

2. Use a Phillips screwdriver to remove the

fuse holder cap on the back of the ampli-

fier, then pull out the cap to remove the

fuse.

3. If the fuse is blown, replace it.

4. Insert the fuse into the fuse holder’s

socket, press the fuse holder back into

the amplifier, then use a Phillips screw-

driver to replace the fuse holder cap.

THE FCC WANTS YOU TO

KNOW

Your amplifier might cause TV or radio inter-

ference even when it is operating properly.

To determine whether your amplifier is caus-

ing the interference, turn off your amplifier. If

the interference goes away, your amplifier is

causing it. Try to eliminate the interference

by:

• moving your amplifier away from the

receiver

• contacting your local RadioShack store

for help

32-2003.fm Page 17 Tuesday, March 28, 2000 10:45 AM

1 2 ... 12 13 14 15 16 17 18 19 20

Pas de commentaire

Radio-shack MPA-125 Manuel d'utilisateur Page 17